Normal tap without thread & screw type inlet hose, Nstallation – LG F84882WH User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
nstallation
Normal Tap without thread & screw type inlet hose
1. Unscrew the fixing screw to
attach the tap.
. Push the connector up tiii the
rubber packing is in tight
contact with the tap. Then
tighten the 4 screws.
Fixing screw
. Push the water suppiy hose
verticaiiy upwards so that the
rubber packing within in the
hose can adhere compieteiy to
the tap and then tighten it by
screwing it to the right.
Normal Tap without thread & one touch type inlet hose
1
. Untighten the upper connector
2.
Push the upper connector up
3.
Connect the water suppiy
hose to the middie connector,
pushing the plate down.
tiii the rubber packing is in
tight contact with the tap. Then
tighten the 4 screws.
Fixing screw
• in case the diameter of the tap is
large remove the guide plate.
Guide plate
Rubber packing
Connector
Plate
Middle-
connector
•Turn the middle connector not
to have water leaked.
• Make sure that the rubber seal
is inside the hose connector.
• To separate the water supply
hose from the middle
connector shut off the tap.
Then pull the inlet hose down,
pushing the plate down.
• Your machine comes with
only cold water connection.
• Make sure that there are no
kinks in the hose and that it
is not crushed.
8 J