Remote controller, Power, Temperature setting – LG WG5005R User Manual

Page 18: Fan speed, On/off timer, Cool/energy saver/fan/dry, Energy saver, How to insert batteries

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Operating Instructions

Remote Controller

CAUTION: The Remote Controller will not function properly if strong

iight strikes the sensor window of the air conditioner or if there are

obstacies between the Remote Controiier and the air conditioner.

Power-------------------------------------------------------------------------

To turn the Set ON, push the button. To turn the Set OFF, push the button again.
This button takes priority over any other buttons.
When you first turn it on, the Set is on the High cool mode and the temp, at 72°F

Temperature Setting-----------------------------------------

This button controls the room temperature setting in a range between

60°F and 86°F in 1 increments.

Fan Speed ---------------------------------------------------

Pressing the Fan Speed button toggles between

Low

and

High speeds.

On/Off Timer------------------------------------------------

- stopping Operation

Each press of the button cycles through the options in this order:

1 Hour—>2 Hours-*3 Hours-*4 Hours->5 Hours->6 Hours-*7 Hours

—>8 Hours—9 Hours—10 Hours—11 Hours—12 Hours—CANCLE.

The set temperature will be raised by 2° F after 30 minutes and again
after another 30 minutes.

- Starting Operation

Each press of the button cycles through the options in this order:

1 Hour—>2 Hours—3 Hours—4 Hours—5 Hours-6 Hours—7 Hours

—8 Hours—9 Hours—10 Hours—11 Hours—12 Hours—CANCLE.

Cool/Energy Saver/Fan/Dry

Everytime you push this button, it will toggle between COOL,

ENERGY SAVER, FAN, and DRY.

Energy Saver

The fan stops when the compressor stops cooling.

Approximately every 3 minutes the fan will turn on and

check the room air to determine if cooling is needed.

How to Insert Batteries

1. Remove the cover from the back of the remote

controller

2. Insert two batteries.

Be sure of the polarity when installing the

batteries.

Be sure that both batteries are new.

3. Re-attach the cover.

Do not use rechargeable

batteries. Such batteries

differ from standard dry cells

in shape, dimensions, and

performance.

Remove the batteries from

the remote controller if the air

conditioner is not going to be

used for an extended length

of time.

18 Room Air Conditioner

Advertising