Checking error messages (cont.) – LG WT4970CW User Manual

Page 31

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING

31

Checking error messages (cont.)

Message

The display shows:

The display shows:

The display shows:

The display shows:

The display shows:

The display shows:

Possible Causes

The washer has detected an out of balance

load.

If the uE rebalance (see above) is not

successful, this error will be displayed.

The load is too small.

Heavy articles are mixed with lighter items.

The load is out of balance.

Thermistor error

The water level sensor is not working

correctly.

Thermal overload protection circuit in the

motor has been tripped.

If an error message is displayed for

4 minutes, the water in the tub will

automatically drain, 'dr' will appear on the

display. You may restart the washer at this

time. However, once the washer initiates

draining, all functions will be suspended,

and 'dr' will be displayed until draining is

complete.

Solutions

If the washer detects a load that is too far out of

balance to spin, it will display this code while it is

attempting to rebalance the load. The washer will add

water and try to redistribute the load automatically.

This display is for your information only, and no action

is required.

The automatic attempt to rebalance the load was not

successful. The cycle has been paused to allow the

load to be manually adjusted.

Small loads may need additional items to be added to

allow the washer to balance the loads.

The load may have heavy items loaded with lighter

items. Always try to wash articles of somewhat similar

weight to allow the washer to evenly distribute the

weight of the load for spinning.

Manually redistribute the load if articles have become

tangled preventing the automatic distribution from

working properly._________________________________________

Unplug the washer and call for service.

Close the water taps, unplug the washer, and call for

service.

Allow the washer to stand for 30 minutes to allow the

motor to cool; then restart the cycle. If the LE error

code still appears, unplug the washer and call

for service.

This is normal.

Advertising