Cable connections – COBY TFTV1524 User Manual
Page 12
6
Figure. Cable connections
Antenna/Power Connection
Connect TV RF sources to the antenna port. TV RF signals include: receiving antenna/CATV net. You
1.
can use 75 Ohm coaxial cable to connect outdoor antenna.
Insert one end of the supplied power cord to the player’s power jack and the other end to the 110-240V
2.
AC wall outlet.
Compoent Input (Y Cb/Pb Cr/Pr)
The component port is capable of accepting high-definition signals from standard video sources. (e.g., cable/
satellite boxes, DVD players, VCRs, etc.)
Connect the Y/Pb/Pr port by the component cable to input the video signal.
1.
Connect “R” "L" port by the supply AV cable to input the audio signal. The red/white plug of the AV cable
2.
is for the audio conneciton and the yellow plug for the video connection.
S-Video Input
The S-Video port is capable of accepting signals from standard video sources. (e.g., cable/satellite boxes,
DVD players, VCRs, etc.)
Connect the S-Video port by the S-Video cable to input the video signal.
1.
Connect the AUDIO-L/R port by the supply AV cable to input the audio signal.
2.
AV Input
The CVBS port is capable of accepting signals from standard video sources(e.g., cable/satellite boxes, DVD
players, VCRs, etc.)
Connect the VIDEO port with the yellow plug of the the supplied AV cable.
1.
Connect the L/R port with the red & white plug of the supplied AV cable to input the audio signal.
2.
VGA Input
The VGA port of the TV is capable of accepting high-definition signals from computers with a VGA output
jack. When used as a computer moniter, connect the VGA jack and the PC Audio In jack with a 15-Pin D-Sub
cable and a 3.5mm stereo audio cable.
HDMI Input
HDMI (High Definition Multimedia Interface) is a new type of connection that transmits digital audio and video
signals simultaneously over a single cable. A HDMI cable is required for the HDMI connection.
These HDMI input connectors are capable of receiving video at resolutions up to 1080p (1080-progressive).
Cable Connections
External AV Source
Set the unit into the relative input mode
to enable the signal pass.