Crestron electronic CNXFZ - Manual (Page 5)

Crestron CNXFZ Focus/Zoom Control Interface
CNX Focus/Zoom Control
Interface: CNXFZ
Description
Functional Description
The CNXFZ is designed to provide network control of a remotely positioned video
camera site. Control is defined as the two-axis motion of the focus/zoom setting and
iris control of a camera lens.
Jumper Boards
Four supplied jumper boards permit the support of any lens assembly requiring an
input voltage in the range of +/-2.5 to +/- 12 VDC. Thus a single CNXFZ with its
four jumpers can control nearly any lens in the industry. Refer to the table below for
exact voltage outputs for each jumper board.
NOTE: If no jumper board is connected to the CNXFZ, the lens outputs are
disconnected.
Jumper Board Options
JUMPER
BOARD
VOLTAGE
CONFIGURATIONS
LENSES CONTROLLED
LENS A +/- 12 VDC differential drive
Panasonic WV-LZ81/10, Canon
J6x11 REA-IA-II, Daiwa/CSI, and
Cosmicar H6ZAHE-2P and
C6Z1218H2ESP-2
LENS B +/- 8 VDC differential drive
H1020812 AMSP, Daiwa/CSI, and
Computar H10Z0812M
LENS C
+/- 2.5 VDC single ended drive
with lens supplied reference
(implements 2.5V to 7.5V with
lens supplied center (5V))
Fujinon MD, BMD and SD series,
JVC HZ-713MD, Daiwa/CSI, and
Canon KTS/KTS-A series
LENS D +/- 6 VDC differential drive Daiwa/CSI and Vicon M & MS series
Operations Guide - DOC. 5753 CNX Focus/Zoom Control Interface: CNXFZ • 1