Clarion TB743W - Manual (Page 24)

24
TB741P/TB742P/TB743W
English
Installation and Wire
connection manual
■
Fixed Mount (TOYOTA, NISSAN and other ISO/DIN equipped vehicles)
This unit is designed for fixed installation in the
dashboard.
If the vehicle is equipped with a factory-installed
radio, install the main unit with the parts and
screws marked (
*) (Figure 8).
If the vehicle is not equipped with a factory-
installed radio, obtain an installation kit to install
the main unit in the following procedure.
1. Remove the screws at both sides of the
main unit and slide the springs to the
direction of arrow and remove them (Figure
7).
2. Secure the mounting brackets to the chassis
as shown in Figure 8. Holes are pre-tapped
for TOYOTA and NISSAN vehicles;
modification, such as drilling new holes, of
the mounting brackets may be required for
other models.
3. Wire as shown in Section 7.
4. Secure the unit in the dashboard, and then
reassemble the dashboard and the center
panel.
*: The parts and screws with this mark
are used to install radio or included in
the installation kit.
The parts and screws with this mark
are originally attached to the vehicle.
★:
Center Panel (Note 1)
Main Unit
Mounting bracket ★
(1 pair for the left and right sides)
Dashboard
Pocket
★
★
★
★
4–Hexagonal screws * (M5
×
8)
Main Unit
2–Springs
Figure 7
Figure 8
2–Screws
Screwdriver
★
★
★
★
Note 2
Note 1: In some cases, the center panel may
require some modification (trimming,
filling, etc.).
Note 2: If a hook on the installation bracket
interferes with the unit, bend and flatten it
with a nipper or a similar tool.