Clarion TB743W - Manual (Page 6)

English
Owner
’s manual
6
TB741P/TB742P/TB743W
Note: Be sure to read this chapter referring to the front diagrams of chapter “1. CONTOROLS” on page 3
(spread).
[OPEN/CLOSE] button
• Use this button to open/close the liquid crystal
panel.
• Press and hold this button for about 2
seconds or longer so that the liquid crystal
panel is positioned horizontally when the
liquid crystal panel is open. Press the button
again to return the panel to the original
position. Even if the button is not pressed, the
panel returns to the original position after
about 10 seconds.
[TILT] button
• Use this button to adjust the angle of the
liquid crystal panel in 5 steps.
• Each time this button is pressed and held for
about 2 seconds or longer, the liquid crystal
panel moves forward/backward in 3 steps.
[ADJ] button
• Shows the ADJUST MODE menu to change
the settings.
[MEMO] button
• Shows the manual memory screen to store
the station.
• Press and hold this button for 1 second or
longer to store the station in manual memory
function.
[PS] button
• Press to perform preset scans.
• Press and hold for 1 second or longer to
perform the auto store operation.
[DISP] button
• Press this button to show the information on
the screen.
• Press and hold this button for 1 second or
longer to switch the display sizes.
[PWR] button
• Press this button to turn on/off the power.
[BND] button
• Press this button to switch the receiving
bands.
• Press and hold this button for 1 second or
longer to turn on/off the monitor.
• Press this button to return to the previous
screen in the adjustment menu screen.
[ a], [d] buttons
• Press to perform the Manual tuning operation.
• Press and hold for 1 second or longer to
perform the Seek tuning operation.
• Press to select the desired mode in
adjustment menu screen.
[ w], [z] buttons
• Press to select the preset channel.
• Press to select the desired menu in
adjustment menu screen.
[SENSOR]
• Remote control infrared sensor.
[RESET]
• Press [OPEN/CLOSE] button or [TILT]
button, the LED of this button blinks.
• Press this button, frequencies of TV, etc.
stored in memory are cleared.
4. BUTTON TERMINOLOGY