AItech ProA/V Media Extender - 5GHz Digital - Manual (Page 5)

3.2 Connect the AV Receiver to an A/V Display
Step 5: Connect one end of the A/V cable (RCA or S-Video) to the audio (B6,
B7), and video (B8 for RCA and B9 for S-Video) output jacks, and
connect the other end of the A/V cable to the display device via its ”AV
input”.
Step 6: Keep the IR window oriented toward front when using your source
device’s remote controller.
Step 7: Power on the AV Receiver by connecting the DC plug of the Power
Adapter to the DC jack (B10), and connect the power supply to an
outlet.
Step 8: The Power on LED (B1) shall be on, the Link LED (B2) shall start
blinking.
Step 9: The Link LED (B2) shall stop blinking and stay in solid in less than 5
minutes. By then, the wireless link is successfully established.
4. Trouble Shooting
After plug the power, the Power on LED (1A or 2A) is not on?
Check the power outlet and make sure the power is on. Then unplug the DC
supply from the DC jack (A10 or B10) and plug it back on. Repeat this a few
times if problem persists.
During the setup, what if the Link LED (1B or 2B) keeps blinking and does
not turn solid on?
This indicates the wireless link is not up yet. Check both AV Sender and AV
Receiver to make sure they are both power on. If the problem still persists, do
following steps:
Step 10: Go to the AV Sender. Press (and release) the Paring button (A5).
The Paring LED (A3) shall be on.
Step 11: Go to the AV Receiver. Press (and release) the Paring button (B5).
The Paring LED (B3) shall be on. It shall quickly go off after the Link
LED (B2) stop blinking and stay solid on.
Note: the Link LED will go off in 45 seconds if there is no wireless link.
If the Link LED continues blinking after Step 10 and 11, you may
have to move the AV Receiver closer to the AV Sender and try the setup again.
After the wireless link established, what if the Link LED (2A) of
AV Receiver changes from solid on to blinking or even off?
This indicates the loss of the wireless link. If the link cannot recover in 5
minutes, reset the power of the AV Receiver.