Alumax 393 - Manual (Page 9)

EPH-N00-06011
5-20-97
Page 9 of 11
16
18
Press the four rail end caps [HH] into the
ends of the top and bottom door rails.
17
Adjust the drip vinyl [W] by sliding it left or
right until it just touches the curb. Trim the vinyl
(flush with the pivot end and notch 1/2" longer
than the drip rail as shown on the strike end).
Secure it with one #6 x 3/8" truss head screw [GG]
in the pivot end of the drip rail [U].
The drip plug [FF] is supplied with a left and right
hand plug together. Break the right and left drip
plug apart and insert the appropriate plug into
the high (strike) side of the drip rail. Discard the
unused drip plug. Peel off the tape backing and
carefully press the drip rail to the door in the marked
position.
Cut the drip rail [U] to the length of the bottom
door rail minus 11/16". Clean the interior face of the
bottom rail and the flat side of the drip rail thoroughly
to ensure proper adhesion of the double stick tape [V].
Unroll the tape and carefully attach it to the back of the
drip rail (do not peel the tape backing yet).
Insert the tapered drip vinyl [W] into the drip rail.
Position the drip rail flush with the bottom and pivot
side of the bottom door rail, then raise the strike side
until the bottom edge of the drip vinyl is parallel to the
bottom of the door. Mark the location of each end of the
drip rail.