Alumax 650S - Manual (Page 8)

EPH-N00-06015
1-29-09
Page 8 of 8
14
Caulk both ends of the tub track [A] where it
meets the wall jambs [B] and the interior edge of the
wall jambs as shown. Run a bead of caulking along the
interior edge of the tub track.
NOTE: We recommend that you let the caulk cure for
24 hours before using your new enclosure.
The Care and Cleaning of your new A
LUMAX
Bath Enclosure. The simplest and preferred
method of cleaning your unit is by washing it with clean water and drying with a soft cloth.
If soil is still present after drying, a non-abrasive cleanser with a pH of seven to eight may
be used. Comet Bathroom Cleaner
® has been tested and is recommended by the Bath
Enclosure Manufacturers Association (BEMA). Do not use scouring pads, sharp instruments,
or acid-based cleansers to clean the unit.
Thank you for choosing an A
LUMAX
Bath Enclosure. Please take a moment to complete
and return the enclosed Customer Response Card. The information you provide helps us
improve the quality of our products and provide better service to you, our customer.
13
Slide the stainless steel bumper inserts [V] into
the two soft vinyl jamb bumpers [W]. Align the slots in
the bumpers with the outer rails of the door panels and
snap the bumpers downward over the center wall jamb
screws
[D] with the nylon spacers [E] (see Step #4).