Alumax 733 - Manual (Page 4)

EPH-N00-06016
6-4-97
Page 4 of 8
Place one curb anchor [AA] against the wall
as shown in the diagram. The top of the curb
anchor should be 3 9/32" above the center of the
shower curb. Mark the hole locations and remove
the curb anchor. With the remaining curb anchor,
follow the same procedure on the opposite wall,
and proceed to drill holes. For fiberglass units
with reinforcement, use a 1/8" drill bit. If there is
no reinforcement, you should use a 7/32" drill bit
and insert a plastic wall anchor [H] in each hole.
Replace the curb anchors and attach with four #8
x 1 1/2" truss head screws [CC].
1
Measure the wall to wall opening at the
shower sill and cut the curb to the exact length.
File the ends of curb as necessary to fit the corner
contours of the enclosure. Temporarily place the
curb [A] on the shower sill with the raised portion
to the exterior of the enclosure. Make sure the
filed radius matches that of the shower sill. Remove
the curb from the sill.
The A LUMAX 733 Pivot Shower Door is
completely reversible and may be installed pivot-
right or pivot-left. Using the diagram, determine
the correct position for your installation. For
maximum waterproofing, the pivot jamb should
always be opposite the shower head. These
instructions depict a pivot-left installation.
CAUTION: For safety, the door must always
open outward.
2
3
3 9 /32 "
MEASURE
SHOWER
SILL
F ILE A S
R E Q U IR E D