Alumax 1050 - Manual (Page 8)

Page 8 of 9 G03711095
11-4-14
12
10
Locate the four, large hole, plastic washers [ M]
and place them over the threads and flush with the four
end caps [
N]. Next, place the four glass inserts [O] onto
the four end caps [ N] and flush with the plastic washers
[ M]. In step 6 the interior and exterior panels were deter-
mined by setting the orientation of the hanger brackets
[
G]. The towel bars [P] will be installed on the same side
of the panels as the rollers in the hanger brackets [ G].
Insert the threaded portion of an end cap [ N] through
one of the holes in a glass panel [ H], making sure that
it is located on the opposite side from the rollers on the
hanger brackets [
G]. Place a, small hole, plastic washer
[ Q] and a metal washer [R] on the end cap threads. Now,
loosely, thread the towel bar [ P] onto the exposed threads
of the end cap [ N]. Make another end cap assembly, and
thread into the other end of the towel bar [ P]. Repeat this
process for the other glass panel [ H], making sure that
the towel bar is located on the same side as the rollers
in the hanger brackets [
G].
Insert the wrench [ S] into the small hole on the
edge of an end cap [ N] and rotate in a clockwise direc-
tion until tight. Repeat for all remaining end caps.
11
Locate one of the clear panel guides [ T] in the
middle of the tub track [ A] with the door panels [H] in
the position shown. With a 7/64" bit, drill a hole into the
V-groove through the mounting hole in the guide. Attach
the center panel guide with a #6 x 3/8" pan head screw
[
U] through the drilled hole.
OPTION (Recommended): Included in your hardware
kit are two extra panel guides and screws that can be
used in the center of each panel opening if desired.
TUB
TRACK
GLASS
PANELS
CENTER
GUIDE
#6 x 3/8"
SCREW
EXTERIOR