Alumax ABSL Series - Manual (Page 4)

4
06.10 K
ABSL66-18L | ABSL66-18R
1
2A.
1A. -
modate plumbing. The 2” (5.0cm) drain pipe should
Note: Dimensions tolerance are ±¼” from wall to
center of drain.
PREPARE DRAINING PIPE.
2
INSTALL THE DRAIN.
Prior to install the drain on the base, run a bead
of silicone between the drain body and shower
base.
Drain not included
Components might vary according to the model of drain used.
Refer to manufacturer’s instructions for the proper installation.
1B. Position base. Verify that the draining pipe location
matches the actual location of the base drain.
Remove the base.
Cover*
Drain body
Shower base
Silicone
Rubber gasket
Cardboard gasket
Drain nut
2A
Top View
* Model ABSL66-18L shown | (left side base)