Attwood 1-Mile Pulsar Pole Mounted Bi-Color Stowaway - Manual

12-Volt 1-Mile
Bi-Color Pole Lights
5091, 5092
Installation Instructions
Attwood marine hardware, navigational lighting, bilge pumps, and
other marine accessories are specified more than any other brand by
America’s best-known boat manufacturers as original equipment.
Look to Attwood for quality replacement parts and marine accessories.
SAVE THESE INSTRUCTIONS
Form Number 69381 Rev. B
03-10
3
®
INSTALLATION
Pole Light
CAUTION:
All positive (+12V DC) wires must be fused to protect your circuits
and vessel. The Universal Fit Light requires a 1-amp fuse. The
aluminum pole of the Universal Fit Light is not connected to an
electrical ground.
Replacing a Light Without a Locking Collar
1. Insert pole into base, aligning screws with slot in base.
2. Press down firmly to engage electrical connectors.
3. Lock pole in position with lock mechanism of base.
4. To remove light, unlock pole from base and pull straight up.
(Figure 2)
Replacing a Light With a Locking Collar
1. Remove both screws from base end of pole.
2. Slide plastic locking collar supplied with Universal Fit Light up over
terminal connector and past screw holes on pole.
3. Replace screw closest to base end of pole only.
4. Insert pole into base, aligning screw with slot in base.
5. Press down firmly to engage electrical connectors.
6. Slide locking collar down to base, rotate until lower ring can be
inserted inside top of base.
7. Press down into base and rotate until locking collar tightens
between pole and base.
NOTE:
Periodically check pole to make sure it is secure.
8. To remove light, rotate locking collar in opposite direction until it
loosens, then pull up on pole. (Figure 3)
After installation, activate lights to verify proper operation. Navigation
light regulations require lights to be operated with a three-position
switch that provides for:
• Running lights (sidelights and all-round light).
• Anchor lights (all-round light only).
• Off.
Figure 2
FEATURES
The new Attwood 12-Volt, 1-Mile Navigation Sidelights for boats
up to 39.6 ft. (12 meters). They feature impact resistant, UV-stable
polycarbonate housings. The lens completely encapsulates the bulb
and socket assembly for a splash resistant seal. Meets USCG CFR
183.810, ABYC A-16 requirements, and all applicable standards as
tested by Imanna Labs, 3/31/1997. 1 Nautical Mile visibility. Uses
Lamp 9235, #906 13V, 6 Candle Power.
REQUIRED FOR INSTALLATION
• Cordless drill with 1/8" (3mm), 3/8" (10mm) and 3/4" (19mm) bits.
• Screwdriver.
• Two #8 or #10 stainless pan head screws per light.
• Non-silicone sealant.
WARNING:
To prevent personal injury, always disconnect the power source
when installing or servicing this product. Always remove the boat
from the water before using 120V AC power tools.
LOCATION
Lights must be mounted so that the light pattern is unobstructed.
Locate Bi-Color combination light in an area as far forward as
possible. (Figure 1)
Figure 1
Green
(Starboard)
Red
(Port)