Attwood Pontoon Bimini Tops - Manual (Page 2)

ATTWOOD LIMITED WARRANTY Attwood Corporation, 1016 North Monroe,
Lowell, Michigan 49331 (“Attwood”) warrants to the original consumer
purchaser that Attwood brand products will be free from defects in materials
and workmanship under normal use and service for five years from the date
of original consumer purchases.
This limited warranty is not applicable if the product has been damaged by
accident, improper installation, unreasonable or improper use, lack of proper
maintenance, unauthorized repairs or modifications, normal wear and tear,
or other causes not arising out of defects in materials or workmanship.
Attwood products are warranted for use on pleasure boats. Any other use —
including but not limited to commercial, racing, or non-marine use — are not
covered under this warranty. Attwood’s obligation under this warranty is limited
to repair of the product at Attwood’s plant or replacement of the products at
Attwood’s option without expense to the original consumer purchaser. Any
expenses involved in the removal, reinstallation or transportation of the product
are not covered by this warranty.
The product must be returned to Attwood’s plant at the address above, postage
pre-paid, and insured with proof of original purchase including date. If Attwood
is unable to replace the product and repair is not commercially practical or
© 2004 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com
INSTALL SUPPORT POLES
1. Mark position of the support pole deck hinges exactly 36" back
of the main deck hinges. Measure from center of the main deck
hinges to center of support pole deck hinges. (See Figure 4)
Support
Pole Hinge
Mid Bow
Long Bow
Main Deck
Hinge
Figure 4 2. Install support pole deck hinges. While installing, fasten clevis
pin cables (one on each hinge) with #10 x 3/4" supplied screws.
3. Install the support pole eye ends into the deck hinges and insert
clevis pins.
4. Spread out the bimini frame and hold it level with the floor.
Extend the tie-down straps forward and mark location for pad
eyes. Measure distance from the main mount deck hinge to be
certain both pad eyes are at equal distance from hinges. At
marked position install pad eyes with provided screws.
5. Clip hold-down straps to the pad eyes. Adjust strap buckles so
top is tight and level.
BUGG Y -STYLE PONTOON (WITH TAILS)
1. To fit tails properly, pull the tails straight down and mark the snap
locations onto rails.
2. Drill 1/8" hole where each snap was marked to rail. Install
supplied screw stud into hole. Repeat for all snaps.
3. Snap tails to the rail.
cannot be timely made, or if the original consumer purchaser is willing to
accept a refund in lieu of repair or replacement, Attwood may refund the
purchase price, less an amount for depreciation. The acceptance by Attwood
of any product returned or any refund provided by Attwood shall not be deemed
an admission that the product is defective or in violation of any warranty.
Products that are replaced or for which a refund is issued become the
property of Attwood.
THIS WARRANTY IS ATTWOOD'S ONLY EXPRESS WARRANTY OF THIS
PRODUCT. NO IMPLIED WARRANTY SHALL EXTEND BEYOND FIVE
(5) YEARS FROM THE DATE OF ORIGINAL CONSUMER PURCHASE.
ATTWOOD SHALL NOT BE LIABLE FOR ANY DAMAGES FOR LOSS OF
USE OF THIS PRODUCT, NOR FOR ANY OTHER INCIDENTAL OR
CONSEQUENTIAL DAMAGES, COSTS OR EXPENSES.
Some states do not allow limitations on how long an implied warranty lasts
or the exclusion or limitation of incidental or consequential damages, so the
above limitations and exclusions may not apply to you. This warranty gives
you specific legal rights, and you may have other rights which vary from
state to state.