Autotech 10.202.3012K/3022K Cold Air Intake Kit, Mk3 2.0L & VR6 OBDII - Manual (Page 2)

19.Install the supplied self-tapping screw into the 1/8” hole, through the tab on the inlet tube
20.Install leak detection pump on the driver’s side of the car in the same manner and location it was installed on the
passenger side from the factory. (only the two top studs will be used, the single bottom stud will not be used with
new mounting location)
21.Rotate the inlet side of the leak detection pump (marked “inlet”, or “filter”) so it points towards the bottom of the front
bumper skin.
22.Install extension harness to the plug removed from the leak detection pump.
23.Route the vacuum hoses and harness extension along the lower radiator core support and attach to the leak
detection pump.
24.Attach the vacuum hoses to the lower radiator support using the supplied zip-ties.
25.Re-install the lower splash guards.
26.Securely attach all vacuum hoses in the engine compartment so they won’t be damaged by engine vibration.