Autotech 10.297.210K-214K SportTuned Aluminized Exhaust System, Mk2 8V & 16V Models User Manual

Installation instructions

Advertising
background image

A

U

T

O

T

E

C

H

Installation Instructions

Phone 949.240.4000 Fax 949.240.0450

32240-E Paseo Adelanto, San Juan Capistrano, CA 92675

PART NUMBER: 10.297.210K; 10.297.211K; 10.297.212K; 10.297.214K

DESCRIPTION: AUTOTECH SPORTTUNED EXHAUST SYSTEM FOR A2 MODELS, 1985-92

As the removal and installation of the A2 VW exhaust system is a relatively simple one,

the purpose of this sheet will be to overview the procedure on how to perform a successful
installation. Please read this entire page before proceeding.

Rear Muffler

Jetta 2

Golf 2

Clamp with hanger
welded on.

Procedure:
Note: Always use gloves and eye protection when working with exhaust system components.

1. Loosen, but do not remove the left rear wheel lug bolts. Jack up the left side of the car and

secure it with jackstands. Remove the left rear wheel.

2. Apply some penetrating oil to the clamp bolts and to the joints themselves and let sit for

10-30 minutes in order to loosen up some of the rust that may have accumulated. This will
make disassembly of your old exhaust system much easier. Loosen the clamp bolts and slide
clamps off the joints.

3. Before installing the AUTOTECH system, first lay out all the components on the ground to

familiarlize yourself with their installed orientation.

4. Remove the old exhaust system, starting from the rear of the car and working your way

forward.

5. Now, loosely install your new system, starting at the front. Start with the front pipe that

slips onto the catalytic convertor, and work your way back. Be sure to install all the
components loosely, so that you can rotate or adjust any pieces for proper fit and alignment.

Figure A

Advertising