AVer W30 quick guide - Manual

Quick Guide
W30 Base Connection Ports and Switches
(1) Connect to output video display on a
projector or monitor.
(2) Connect to output video display on a
TV or VCR.
(3) Connect to display video signal from a
computer.
(4) Connect to a computer serial port or to
any control panel or for centralized
control system thru RS-232/CBVS
cable.
(5) TV : select to output video signal to
RS-232/CVBS port.
RGB: select to output video signal to
RGB OUT and DVI-I OUT port
(6) Insert an SD card. The captured image
can be saved directly to this card.
(7) Connect to computer via USB cable.
The switch must be set to . This
allows you to use W30 as webcam or
transfer file.
(8) Insert a USB flash drive. The captured
image can be saved directly to this
flash drive. The switch must be set to
.
(9) Set the display output resolution. You may
refer to the table printed on the side.
(10) Connect the power adapter into this port.
W30 Base Control Panel
Name Function
(1) POWER Turn the unit on/standby mode.
(2) AUTO FOCUS Adjust the focus automatically.
(3) RECONNECT Reconnect the W30 camera and base.
(4) SOURCE Select to display CAM, RGB IN, PLAYBACK, CAM/RGB IN, SPLIT
SCREEN or PIP mode.
(5) FREEZE - Freeze live images in camera mode.
- Pause slide show in playback mode.
(6) CAP/DEL - Capture still image in Camera mode. In continuous capture mode,
press this button again to stop.
- Delete the selected picture in Playback mode.
(7) MENU Open and exit the OSD menu.
(8)
- Make a selection in Playback mode and OSD menu.
- Play/Pause picture slide show.
(9) Show the wireless signal condition.
 Steady Green - binding the W30 camera with the W30 base.
 Continuous Green Flashing - data transition. It sends the W30 camera
data to W30 base.
(10) USB Switch LED Indicate the USB switch selection to show which USB port is activated.
-
allowing you to use the W30 as USB camera or transfer the
captured images from the memory to computer.
- allowing you to save still image in the USB flash drive.
(11) OUTPUT LED Indicate TV-RGB switch selection to show which port the video signal is
sent out.
- RGB indicates the video signal is sent out thru RGB OUT and DVI-I
OUT ports.
- TV indicates that the video signal is sent out thru RS232/CVBS port via
RCA connection.
(12) ▲,▼,◄, & ► - Pan the image when image is magnified in playback and camera mode.
- Move the selection in Playback mode and in OSD menu.
P / N 3 0 3 A P 0 A W - A E 3
M a d e i n T a i w a n