Clarion M455A - Manual (Page 10)

10
M455A
280-8402-00
English 5. DETACHABLE CONTROL PANEL
CAUTION
Removing the DCP
1. Press the [SRC] button for 1 second or
longer to switch off the power.
2. Press in the [RELEASE] button.
[RELEASE] button
3. Remove the DCP.
DCP
Attaching the DCP
1. Insert the right side of the DCP into the
source unit.
2. Insert the left side of the DCP into the source
unit.
DCP
2.
1.
• The DCP can be damaged by impact. After
removing it, be careful not to drop or
subject it to strong shocks.
• The connector connecting the source unit
and the DCP is an extremely important
part. Be careful not to damage it by
pressing on it with fingernails,
screwdrivers, etc.
DCP Rear Panel Source Unit Front
Source unit connector
DCP
connector
Note:
• If the DCP is dirty, wipe off the dirt with a soft, dry
cloth only.
Storing the DCP in the DCP Case
Hold the DCP, in the orientation as shown in the
figure below, and put it into the supplied DCP
case. (Ensure the DCP is in the correct
orientation.)
DCP
DCP case