AVer M50(355AF) user manual - Manual (Page 8)

ENGLISH
3
Name Function
(2) USB Flash Drive port Insert a USB flash drive for audio video recording.
(3) Power button Turn the unit on/standby mode.
Rear Panel
(3)
(1)
(2)
(fig. 1.3)
Name Function
(1) DC12V port
Connect the power adapter into this port.
(2) DVI-I OUTPUT port
Connect the AVerVision M50 to any display device with DVI
cable.
If the display device does not support DVI-I, you can only
view in Camera and Playback mode.
(3) RGB OUTPUT port
Connect the AVerVision M50 to any display device with RGB
cable
Left Panel
(1) (7)
(5)
(6)
(4)
(3)
(2)
(fig. 1.4)
Name Function
(1) Mini USB port
Connect to a USB port of a computer with a USB cable and use
AVerVision M50 as a USB Camera or transfer the captured
images/videos either from the memory source to computer.
(2) RGB INPUT port
Input the signal from a computer or other sources and pass it
through to the RGB OUTPUT port only. Connect this port to the
RGB/VGA output port of a computer.
(3) MIC port
Connect a 3.5mm plug microphone. The built-in mic will be
disabled when an external MIC is connected to this port.
(4) Speaker port
Connect to an amplified speaker to playback recorded audio &
video clip.
(5) RS-232/CVBS port Connect the supplied RS-232/CVBS cable into this port. The RCA
jack outputs the video signal from the camera to a TV or video
equipment. The RS-232 jack is used to connect to computer serial
port or to any control panel or for centralized control if desire.