AVer SPB350+ - Manual (Page 5)

3
ENGLISH
M M a a k k i i n n g g t t h h e e C C o o n n n n e e c c t t i i o o n n s s
The ports on the rear, left and right panel of SPB350+ enable you to connect the unit to a computer, graphics
display monitor or LCD/DLP projector, TV or other device. Illustrated below are the ports that are located at the
rear and right panel of SPB350+ with their corresponding labels.
Rear Panel
(1) (2) (3) (4)
RS-232 DC 12V RGB IN 2 RGB IN 1 RGB OUT
IOIOI
Name Function
(1) DC 12V : Connect the power adapter into this port.
(2) RS-232 : Receive command from the computer to operate
SPB350+. Connect this port to the RS-232 port of the
computer.
(3) RGB IN 1 & RGB
IN 2
: Takes as input the signal from a computer or other sources
and pass it through to the RGB Output and DVI-I port only.
Connect this port to the VGA output port of the computer.
(4) RGB OUT : Output the signal from the camera, RGB IN port, or the
captured images from the memory source on a VGA/Mac
monitor or LCD/DLP projector.
Left Panel
(1) (2) (3) (4) (5)
SD CARD USB DVI-I OUT CVBS OUT S-VIDEO OUT
Name Function
1. S-VIDEO OUT : Output the signal from the camera or the captured images
from the memory source on TV or Video equipment.
2. CVBS OUT
(RCA/Composite)
: Output the signal from the camera or the captured images
from the memory source on TV or Video equipment.
3. DVI-I OUT : Output the signal from the camera, RGB IN 1/2 port, or the
captured images from the memory source on a VGA/Mac
monitor or LCD/DLP projector with DVI-I interface. If the
display device does not support DVI-I, it can only display
the signal from the camera and the captured images.
The1920 X1080 resolution for DVI-I support reduced
blanking only.
4. USB : Use SPB350+ as a USB Camera or Mass Storage to
transfer the captured images from SPB350+ memory
source to PC.
5. SD card slot : Insert the SD card with the label facing up. It can support
16MB~2GB card capacity and only accepts FAT16
formatted card.