AZZA GT 1 - Manual (Page 9)

9.5.25” Device Installation
10.3.5” HDD and 2.5” HDD /SSD Installation
9.1 Pinch the 5.25” drive bay metal mesh to remove it from the front panel
9.2 Slide the 5.25” drive into the appropriate bay until the latch locks into place
9.3 To remove the 5.25” device, please push on the lever and push the device out
10.1 Connect the 4pin Molex connectors from the power supply to the Easy Swap Molex connectors
10.2 Connect the SATA connectors from the motherboard to the Easy Swap SATA connectors
10.3 Pinch the 5.25” drive bay metal mesh to remove it from the front panel
10.4 While pressing on the lever, pull the HDD tray out and place the 3.5” HDD or 2.5” SSD/HDD on the
tray and secure with screws
10.5 Slide the HDD tray into the appropriate bay until the latch locks into place then put back the 2.25”
metal mesh cover
Warning: The computer must be turned off before you install or remove an HDD from an Easy Swap bay
11.How to Remove Fan Nylon Rivet
11.1 Pull the nylon rivets out to remove these fans
11.2 Push in the nylon rivets to replace these fans