AZZA SIRIUS 206S - Manual (Page 6)

Installation Instruction
1.Opening the case
3.Power supply installation
4.5.25” floppy device installation
2.Front panel disassembly
1.1 Remove the thumbscrews from the side panel
1.2 Slide the side panel toward the rear to open the case
3.1 Place the power supply into its proper location
3.2 Tighten the screws
4.1 Remove the mesh cover on the front panel covering the drive bay by pressing
4.2 One (either left of right) of the two tabs inward to unlock, as in the direction shown in the figure
4.3 Slide the device into the drive bay
2.1 Put your hand on the bottom of the front panel than pull it out