B&M 10300 DEEP PAN, CHRYSLER NAG-1 - Manual (Page 2)

Figure 2
Figure 1
bolts and hold downs while support-
ing the oil pan. Remove the last two
bolts and hold downs slowly while
tilting down the pan to allow the last
of the fluid to drain. After the last
bolts are removed, the pan and gas-
ket can be lowered and set aside.
STEP 5. Remove the magnet from
the pan, fully clean it and set it
aside.
STEP 6. The oil filter will now be
exposed. Pull the filter out of the
valve body, being careful not to
bend the filter pickup tube as it is
plastic and may crack or break. If
the seal remains in the valve body
and does not come out with the fil-
ter, remove it by using a flat head
screwdriver. Be careful not to dam-
age the surface.
STEP 7. Install the supplied o-ring
on the extension tube provided in
the kit
(See Figure 1). B&M rec-
ommends that the transmission filter
be changed at this time. Lubricate
the seal on the transmission filter
(MOPAR p/n: 52108325AA) and the
o-ring with new transmission fluid.
Place the extension tube on the
transmission filter
(See Figure 2).
STEP 8. Install the filter assembly
into the valve body
(See Figure 3).
STEP 9. Make sure the flat end of
the filter is parallel to the back of the
transmission
(See Figure 4).
STEP 10. Stick the magnet removed
earlier on the bottom of the trans-
mission filter as shown
(See Figure
5).
STEP 11. Install the reusable gasket
(MOPAR p/n: 52108332AA) onto the
B&M Cast Aluminum Deep Oil
Pan.
STEP 12. Clean the transmission
mating surface with a clean rag.
STEP 13. Install the B&M Cast
Aluminum Deep Oil Pan by using
the supplied hold downs with the
original six bolts removed earlier
and torque the bolts to 8 N-m (70
in.lbs.). Do not over tighten as this
can cause leaks or damage to the
transmission case or gasket.
STEP 14. Using a 3/4” socket &
ratchet, install and tighten the sup-
plied drain plug and gasket.
STEP 15. If using a temperature
sensor, install in provided 1/8
” NPT
port on side of pan. Otherwise install
Figure 3
Filter Assembly
Valve Body
Extension Tube O-ring
Extension Tube
Filter