B&M 35498 BRACKET AND LEVER KIT - Manual (Page 2)

might be required for the 4L80E
and 4L85E. Verify that selector le-
ver does not grind on cable bracket
before moving on to step 3.
STEP 3. Route the shifter cable ac-
cording to Figure #2. Avoid kinks and
sharp bends and route the cable away
from hot engine or exhaust parts. Re-
move the two rubber boots, one large
nut, and a large lockwasher from the
threaded end of the shifter cable. Slide
the end of the cable into the cable
bracket. Install the large nut and lock-
washer loosely over the end of cable.
Install the two rubber boots onto the
end of the cable. Install the swivel on
the threaded end of the cable and
position it in the center of the threaded
portion.
STEP 4. Move the transmission se-
lector lever by hand to the full rear
position (LOW). Place the shifter lever
to the LOW gear position (all the way
back). Adjust the large nuts on the
cable so that the swivel will slide into
the correct hole (see the list below) on
the selector lever. Tighten the large
nuts completely. Be sure that the swivel
will slide freely in and out of the hole in
the selector lever. Note: The shifter
will not operate correctly unless
the correct hole in the selector le-
ver for your shifter is used.
Leave the swivel out of the hole and
move the selector lever to PARK, all
the way forward. Also move the shifter
to the PARK position (all the way
forward). Reinsert the swivel into the
correct hole in the selector lever. Check
to see that the swivel will slide freely in
and out of the front hole in the selector
lever in this position. If it does not slip
in freely, adjust the swivel slightly until
it will slip into the hole in the lever.
Move the shifter back to the LOW
gear position and check that the swivel
will still slide easily in and out of the
correct hole in the selector lever. (If you
do not use the correct hole in the lever,
it will be impossible to correctly adjust
the cable.) Operate the shifter through
all the gear positions. Check to make
sure the swivel will slide in and out of
the correct selector lever hole in each
gear position. The shift cable is now
correctly adjusted. Install the cotter
key supplied with the shifter into the
swivel and spread the key ends.
If you have a problem, DO NOT
FORCE THE SHIFTER, this will dam-
age the cable, the shifter or the trans-
mission. Simply start at the beginning
Figure #2
GM cable bracket
Spacer
See the chart below to
find out which hole is
correct for your shifter
and transmission
Figure #3
GM lever
Center hole Front hole
Selector Lever Hole Usage
FRONT HOLE CENTER HOLE
Megashifter, Hammer Star Shifter
Pro Stick, Street Stick Quick Click
Sport Shifter, Unimatic Quick Silver #80676
QuickSilver #80683 Z-Gate
Pro Ratchet #80842 Pro Ratchet #80841
Note: The shifter will not operate correctly unless the
correct hole in the selector lever for your shifter is used.