B&M 70235 TRANSPAK - Manual (Page 9)

STEP 17. With the 3-4 accumulator
components and case check balls in
place, place the separator plate / gas-
ket assembly up to the case followed
by the 1-2 accumulator housing as-
sembly. Carefully line up the gaskets
and install three accumulator housing
bolts, tighten ONLY finger tight (See
Fig’s. 2, 10 and 11.)
STEP 18. Install the auxiliary valve
body (with check ball in correct posi-
tion) or cover plate using the appropri-
ate screws tightened ONLY finger tight
(See Fig’s. 2 and 8.)
STEP 19. Valve body installation.
Make sure check balls are in proper
locations. Position the manual valve so
the link rod can be engaged (See Fig.
6.) The link rod must be placed into the
hole of the manual rod at a right angle,
then rotated to allow the valve to enter
the valve body bore. Do not force the
valve at any time. When the valve is
fully engaged, align the valve body and
Figure 12
Figure 13
case holes then install one bolt finger
tight to hold valve body in place. En-
gage all of the remaining bolts to finish
lining up the separator plate and gas-
kets (See Fig. 2.) Tighten all the valve
body, auxiliary valve body (or cover)
and accumulator bolts (except cross
over tube clamp bolts and throttle
valve linkage bolts) to 11 NM (8 Ft.
Lb.) Avoid striped threads, Do not
over tighten bolts.
STEP 20. Install the throttle valve (TV) linkage onto the valve body as shown
(See Fig. 12.) Engage the cable link
with the large lever first. Hold the large
lever up and the smaller one down.
Then slip the assembly into position
aligning it with the hold down bolt holes
and engage the roll pin in the slot on the
bracket. Insert bolts and tighten to 11
NM (8 Ft. Lb.) then make sure large
lever operates freely. IMPORTANT
NOTE: The TV cable MUST be reset
before operating vehicle refer to step 25.
STEP 21. Carefully insert ends of
cross over tube in their respective bores
and push in evenly until fully engaged
(See Fig. 2.) Install cross over tube
bolts and clamps and tighten to 11 NM
(8 Ft. Lb.)
Reconnect wiring harness connectors
to the terminals from which they were
removed. Refer to sketch or notes made
at Step 3. Reconnect the harness to
the case connector making sure it is
9