B&M 70465 PRO LEVER - Manual

Installation Instructions
Powerglide Pro Lever
Part No. 70465
©2012, 2002 B&M Racing & Performance Products
Use this hole for Hurst shifter
(except Hurst Quarter Stick 2)
and B&M Bandit shifter,B&M
Pro Bandit, Pro Stick.
Use this hole for B&M
Megashifter or late model
Pro Ratchet or QuickSilver
(See illustration on next page
to identify Pro Ratchet or
QuickSilver type)
Use this hole for B&M Star
Shifter, Z-gate, Quick Click or
early model Pro Ratchet ar
QuickSilver (See illustration on
next page to identify Pro
Ratchet or QuickSilver type)
(Can be used on newer model
Hurst Quarter Stick 2 shifters
that have an adjustable cable
end swivel ONLY).
Use this hole for Turbo Action
shifter
The B&M Pro Lever is de-
signed for use on aluminum
Powerglide transmissions with-
out the throttle lever and shaft. It
is a two piece lever rather than
the usual one piece lever. It has
four holes for the cable swivel
so that it can be used with B&M,
Turbo Action or Hurst shifters.
The B&M Pro Lever must be
used with either a manual valve
body or with a trans brake. The
lever can not be used with an
automatic valve body since
there is no provision for a throttle
linkage lever.
The shaft portion of the lever
is installed in the transmission
in the normal Powerglide man-
ner. The lever is then put over
the end of the shaft with the
lever pointing down (for a stan-
dard installation). The cable
bracket for your particular shifter
is bolted on, the cable is in-
stalled in the bracket and the
swivel is screwed onto the cable.
The swivel is then inserted into
Printed in U. S. A. 9500508-03
NOTE: On some Hurst shifter applications the swivel hole may need to
be filed slightly larger to accommodate the cable swivel.