B&M 81035 CONSOLE MEGASHIFTER FOR 68-69 CAMARO - Manual

MEGASHIFTER, UNIMATIC,
PRO STICK, SPORT SHIFTER,
HAMMER, QUICKSILVER #80683 W/4-SPD,
PRO RATCHET #80842 W/4-SPD
STEALTH PRO RATCHET #81120 W/ 4-SPD
BANDIT SHIFTER W/ 4-SPD
Z-GATE, STARSHIFTER,
QUICKSILVER #80683 W/ 3-SPD,
PRO RATCHET #80842 W/ 3-SPD
INSTALLATION
Note: Be careful. Select the correct hole for your
shifter. Wrong hole will destroy the cable, shifter
and/or transmission in one shift! (GM trans. only)
Note: Do not kink cable anywhere along it’s length.
If cable has a kink, it will lock up. Cable should be
kept straight for 2 inches on each end where it leaves
the brass. Any of the above will destroy the cable,
shifter and/or transmission in one shift!
DO NOT KINK CABLE
Cable Adjustment Warning
©2010 by B&M Racing and Performance Products
GM TH-200,TH-350,TH-400,TH-200-4R
TH-700-R4, 4L60, 4L60-E, 4L65-E, 4L80-E & 4L85-E
lever shown.
MELTED CABLES
Note: if your cable is close to your exhaust it will
melt or become brittle. If this is the case, you will
need to make a heat shield. Do not wrap the cable,
this retains heat.Heat will destroy the cable!
Note: if you don’t adjust the cable correctly, you will
destroy the cable, shifter and/or transmission in one
shift. Put the transmission in low gear and shifter in
low gear, set the swivel so it slides in and out of the
correct hole freely(See installation picture). Then
move the transmission and shifter to park (all the
way the other way) then rotate the cable swivel until
it slips in and out of the hole freely. Now go back
and forth between Park and low gear and fine tune
the adjustment. See instructions for further details.
CABLE ADJUSTMENT
9500535-06