B&M 80776 SPORT SHIFTER - Manual (Page 4)

4
Figure 5
Figure 4
ignition switch to the solenoid on the
starter. This wire is usually a 10 or 12
gauge purple wire. Run wires from both
ends of the cut wire to the switch on the
shifter. Put slip on terminals on the ends
of the lengthened wire. Crimp terminals
onto the wires using a crimping tool or
pliers. Connect the neutral safety wires to
the INNER switch and the reverse light
wires to the OUTER switch (See Figure 2). Tape terminal connections and all
other connections to prevent shorts. Re-
connect the battery ground cable, dis-
connect the coil wire and set the parking
brake. Check the switch operation by at-
tempting to start the motor in each shifter
position. The starter must crank only
when shifter is in the Park or Neutral
position. Adjust the switch if required.
Reconnect the coil wire. Go to Step 28. FORD
STEP 16. If you have not already done
so, remove the nut and lockwasher
holding the downshift linkage onto the
downshift lever shaft. The downshift le-
ver is the outer lever on C-4, C-5, C-6
and AOD transmissions. Pull the lever
off the shaft and allow the linkage to
hang free. Remove and discard the stock
Remove shaded
portion of lever
7/16" nut
C-4 cable bracket
Cable swivel
Cotter pin
1/4 x 1-1/2" bolt,
lockwasher and nut
Ford C-4 and C-5
Ford lever
GM Transmissions: "F" Hole cable setup shown
(Use middle hole
for 3spd)