B&M 81035 CONSOLE MEGASHIFTER FOR 68-69 CAMARO - Manual (Page 4)

Check List
___ Ignition/steering column lock works correctly. Key can be removed and steering column locks when key is removed.
___ Cable is securely fastened to shifter and end is held with E-clip.
___ Cable is routed correctly, securely fastened to transmission, and swivel is held with cotter key.
___ Shifter is properly adjusted.
___ The neutral start and reverse light switches are connected and properly adjusted to prevent engine from starting in forward gears and reverse.
___ There is no debris in shifter mechanism.
___ Cover plate is securely fastened and shift position indicator is operating properly.
___ Shifter moves freely in all positions as described in Shifter Operation.
___ If your shifter is not working properly do not attempt to drive your vehicle. Make sure you have followed all instructions. If the shifter is broken
or defective return it to your B&M dealer.
Tool List
1 Floor Jack and Jack Stand(s)
1 Small Flat Head Screwdriver
1 Ratchet
1 1/4" socket
1 7/16" socket
1 1/2" socket
1 13mm socket
1 1/4" wrench
1 7/16" wrench
1 1/2" wrench
1 3/4" wrench
1 wire stripper
1 wire crimper
1 electrical tape
GM Transmissions
GM cable bracket (Trimming of bracket
required if used on cast aluminum pan)
Use these two holes for
TH-400 transmission. Use
other two holes for other
GM transmissions
Spacer
GM lever
GM cable bracket
Cable swivel
Cotter pin
(Use front hole)
5/16 x 1" bolt and spacer
(Metric trans use M8 x 25 bolt)
7/16" nut
F
C
R
4
Note: Sharp bends will kink and damage cable.
Route cable as
shown