B&M 81111 AUTOMATIC SHIFTER, STEALTH PRO BANDIT MAGNUM WITHOUT ACCESSORIES - Manual (Page 6)

tion. The trigger is not required to pull
the stick back to Low gear from Neu-
tral. The third detent will be the High
gear position and the fourth detent will
be the Low gear position.
From Low gear, to shift forward to High
gear just push the stick forward, this
gate is accessible without having to
squeeze the trigger. From High gear
position to access Neutral, squeeze
the trigger and push the stick forward,
this is Neutral for drive around pur-
poses. For true Neutral, you must
push the red reverse lockout lever for-
ward. (Do not hold your hand on the
shifter stick. The stick will move
forward internally by the spring
loaded mechanism). Once the lock-
out lever is forward and the shifter stick
has automatically clicked forward. The
lockout mechanism will now stay open
on it’s own, with no assistance from
the driver. At this point the shifter is in
the true Neutral position. To access
Reverse from the true Neutral position,
simply push the shifter stick forward,
without squeezing the trigger. Squeez-
ing the trigger will open the next gate,
which will be the Park position.
If you wish to rearm the reverse lockout
from the true Neutral position, pull
back slightly on the shifter stick and
you will see the lockout lever snap
back into the lock position.
Optional/Replacement Products
#80710 3-Speed/reverse pattern valve body
#80711 3-Speed/forward pattern valve body
#80712 4-Speed/forward pattern valve body
#80609 Replacement Neutral Safety Switch
#80883 Air Slave Cylinder with bumper
#80323 Quick Disconnect & Cable Extension
#80880 Electronic Control Valve
#80834 8' Super Duty Race Cable
#80833 5' Super Duty Race Cable
#80832 4' Super Duty Race Cable
#80831 3' Super Duty Race Cable
6
2"
Figure #1
81046:
1 Magnum Grip Pro Bandit Shifter
1 Accessory Bag
1 Neutral Safety Switch Wires
1 Installation Instructions
81045 Also Includes:
1 Accessory Bag
1 #80834 Super Duty Race Cable
1 #80323 Quick Disconnect Kit
1 #70465 Pro Lever Kit
1 Neutral Safety Switch Wires
1 Installation Instructions #2 B&M
hole
Jam nuts will
allow positioning
in or out
B&M
1
T
2
H
Photo #10
Figure #2
Mid plate
(out line)
5/16" out
from dowel pin
hole center
Mid plate
7" down from
center of
dowel pin
Drill 7/16" hole
for cable anchor
(Visit www.bmracing.com for additional products and product information)