Esselte LCD2622 - Manual (Page 7)

-6-
Thank you very much for purchasing this TV. To enjoy your product from the very beginning, read this
manual carefully and keep it handy for easy reference.
INSTALLATION
CAUTION
Locate the TV in the room where light does not strike the screen .
Total darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect lighting is
recommended for comfortable viewing.
Allow enough space between the TV and the wall to permit ventilation.
Avoid extremely warm locations to prevent possible damage to the cabinet or premature component
failure.
This TV can be connected to AC 100-240 Volts. 50/60 Hz. Never connect to a DC supply or any other
power supply.
Do not cover the ventilation openings when using theTV.
directly
Never tamper with any components inside the TV, or any other adjustment controls not mentioned in this
manual. All LCD-TVs are high voltage instruments. When you clean up dust or water drops on the LCD
PANEL or CABINET, the power cord should be pulled out from the receptacle, then wipe the TV with
a dry soft cloth. During thunder and lighting, unplug the power cord and antenna cord to prevent damage
to your TV.
All repairs to this TV should only be performed by qualified TV service personnel.
Earthing
connection--- The apparatus shall be connected to MAINS socket outlet with a protective
earthing connection
MAINS plug or appliance coupler of the apparatus is used as disconnect device, it should remains
readily operable
Warning: Change or modifications to this unit not expressly by the part responsible for
compliance could void the user 's authority to operate the Equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designcd to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected .
-Consult the dealer or an experienced radio TV technician for help.
Shield cables must be used with this unit to ensure compliance with the Class B FCC limits.
NOTE:
SAFETY AND WARNINGS