Brondell H2O+ Water Pitcher Filtration System - Manual (Page 7)

Performance Data Sheet
The Brondell H20+ water pitcher filtration system reduces many contaminants from tap water.
Product Specifications:
*Rated Filter Capacity: 42 Gallons
*Filter Capacity per Day: 2.6 Gallons
Model: H10-W, H10-B
Filtered Water Pitcher
Replacement Part Number: HF-10
Substance
Influent Challenge
Concentration
Influent Water Test Conditions
Chlorine
1.99 ppm 0.04 ppm 98% N/A N/A 22 7.82 50% Reduction 2.0 +/- 0.2 ppm
2.8 ppm 0.26 ppm 90.8% 16 18 22 6.50 1.3 ppm a 3.0 +/- 0.3 ppm
3.0 ppm
31 ppb 5 ppb 1.3 ppb
0.43ppm 85.6%
95.8%
112 111 22 8.50
14 12 22 6.55
1.3 ppm a 3.0 +/- 0.3 ppm
30 +/- 3.0 ppb
29 ppb 5 ppb .75 ppb 97.4% 103 108 22 8.56 30 +/- 3.0 ppb
Copper
Copper
Average Average
Filter
Effluent
Removal
Efficiency
Average NSF Std
NSF/ANSI Standard 42 - Aesthetic Effects
NSF/ANSI Standard 53 - Health Effects
Cadmium
Cadmium
Hardness
(ppm CaCO
3
)
Alkalinity
(ppm CaCO
3
)
Temp
(˚C) pH
*The US EPA levels are Maximum Contaminant Levels (MCLs) and are the same as the NSF Maximum Permissible
Product Water Concentrations listed in NSF / ANSI 42 and 53 unless noted otherwise.
a = US EPA Action Level N/A = Not Applicable
Claims are based on testing performed under standard laboratory condition according to NSF/ANSI 42 and 53
for reduction of the substances listed. The concentration of the indicated substances in water entering systems
was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as
specified in NSF/ANSI 42 and 53. The contaminants or the substances removed or reduced by this water
treatment device are not necessarily in all user’s water. The performance of the filter may vary based on local
water conditions.
Do not use with water that is unsafe or of unknown quality without adequate disinfection before or after the
system. Individuals requiring water of specific microbiological purity should consult their physician.
The Brondell H20+ Filter Pitcher processes approximately 42 gallons/160 liters of water. For optimal
performance, replace the filter when it exceeds filtering capacity. Refer to the Use and Care portion of the
Owner’s Manual for this pitcher for proper unit operation and maintenance requirements. Hot water should not
be used with the Brondell H20+ Pitcher Filter (Maximum 85˚F / 33˚C - Minimum 29˚F / .06˚C).
Minimum %
reduction
requirement/
Max effluent
concentration
Estimated Cost of Replacement element: HF-10 Water Pitcher Filters, Pack of 3 - $16.95
Tested and Certified by WQA against
NSF/ANSI 42 for the reduction of Aesthetic
Chlorine and to NSF/ANSI 53 for the
reduction of Cadmium and Copper as
verified and substantiated by test data.