CASO Germany W2100 (2220) - Manual (Page 44)

caso W2100 44
Please note
► We recommend to select the function “Power Mode” in case of steaming food or
boiling water for example. So the overheating protection “E05” will not be activated.
15.4.3 Temperature Mode
• Press the Function Key 3. to select the temperature. The preset temperature stage
"120°C" is selected and the device turns on.
• With the + / - keys, you can change the settings at any time in a range from 60 –
240°C. (Temperature stages: 60, 70, 80, 90, 100, 120, 140, 160, 180, 200, 220 and
240°C).
• Please note that the two functions of level and temperature can be chosen as
alternative. You can either work with the power levels or with the temperature stages.
The most recently selected function is active.
• The temperature is measured by a sensor below the glass ceramic plate, therefore the
displayed temperature can deviate from the temperature in the pot.
Please note
► In case of grilling or cooking deep fry food we would advise you to use the function
“Temperature” as in this case you can use temperatures up to 240°C. Otherwise the
overheating protection “E05” will be activated.
15.4.4 Timer
•
Timer Function. Press the button Timer 2.
•
With the +/- keys, you can now select the operating time in 1-minute intervals (up to
max. 180 minutes). Once the time is up, an acoustic signal sounds and the device
automatically goes into standby mode.
Please note
► During timer operation, you can change the duration at any time with the +/- keys. With
the memory function of the device, the power stage or temperature settings remain
unchanged here.
15.4.5 Switching Off
• When you switch off the device via “On/Standby” and the temperature of the cooker
plate surface is lower than 50°C, the display shows „L“. When the temperature of the
cooker plate surface is over 50 °C, it is displaying „H“.
Please note
► Do not place any empty cookware on the ceramic field. Heating an empty pot or pan
activates the overheating protection and the device turns off.
► Do not operate the device if it is damaged in any way or does not function properly.