CASO Germany MCG 20 chef - Manual (Page 67)

caso MCG20 Chef 67
 Activating input mode
Select input mode by pressing the button Time/Weight once.
 Starting automatic defrost
After setting the defrost time, press the control dial on the device (Start
/Quick start button), to start automatic defrosting.
Please note
► Stop the oven occasionally to remove the unthawed frozen food or to separate it. If the
frozen food has not been defrosted at the end of the estimated defrosting time, proceed
as follows:
► Programme the oven in 1 minute increments, until the frozen food is completely
defrosted.
► When using plastic containers out of the deep-freeze, the defrosting process should
only last long enough to be able to remove the frozen food out of the container, after
which it can be placed into a microwave-resistant container.
13 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.
13.1 Safety information
Attention
Please observe the following safety notices, before you commence with cleaning the
device:
► The oven must be cleaned and food residues must be removed at regular intervals. If
the oven is not maintained in a clean condition, this will have a detrimental effect on the
service life of the device and can also result in a dangerous condition in the device as
well as in the growth of fungus and bacteria.
► Switch the oven off prior to cleaning it and unplug the plug from the wall power outlet.
► The cooking chamber is hot after it is used. There is a danger of burns! Wait until the
device has cooled down.
► Clean the cooking chamber after use as soon as it has cooled down. Extended waiting
unnecessarily complicates cleaning and can make it impossible in extreme cases.
Excessive accumulations of dirt can even damage the device under certain
circumstances.
► If dampness penetrates into the device, this can damage the electronic components.
Please ensure that no liquid can enter the interior of the device through the ventilation
slots.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.