CASO Germany WineSafe 12 (622,624) - Manual (Page 28)

caso WineSafe 28
10.5.3 The handle installing
The wine cooler comes with one metal stainless steel handle. To install simply screw them to
the door with the supplied screws.
Then replace the door seal on again in
the correct position.
10.5.4 Wine shelves
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out. Any of
the wine shelves can be removed to accommodate larger bottles.
Normals shelve bottom shelve
Storage on the bottle size and kind.
10.5.5 To remove a shelf
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out.
Please note
► Ensure that the tabs are firmly engaged in place before storing any bottles.
► Any of the wine shelves can be removed to accommodate larger bottles.
► Spread your bottles out as evenly as possible over the shelves, so weight is not
concentrated in one point; and make sure your bottles will not touch the back of the
cabinet.
10.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out switch.