CASO Germany VC 100 Vacuum System - Manual (Page 41)

caso Vakuumierer VC100
41
 Vacuum interface:
Unbag the airproof loop of sponge from the interface and put it into warm and soapy water
for safe washing.
Please note
► The airproof loop of sponge should be dried thoroughly prior to reassembling.
► When re-assembling, be careful to prevent any damage and assembles as original
position to ensure no vacuum leaking.
16 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
16.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
16.2 Cause and Action
In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error Possible cause Rectification
Vacuum unit is not
functioning
Power plug is not plugged in Plug in mains plug!
Defective power cable or
plug Send device to Customer
Service
Defective electrical socket Select another electrical socket
The first weld on the cut
off piece of the roll is not
being carried out.
Roll is not positioned
correctly
Follow the steps in the chapter
“Vacuum packaging in a bag
originating on the roll”
A complete vacuum is
not being created in the
bag.
The open end of the bag is
not completely inside the
vacuum chamber
Position the bag correctly
The bag is defective Select another bag
There is dirt on the welding
and the normal seals Clean the seals and retry
correctly once they are dry