CASO Germany UltraSonicClean - Manual (Page 29)

caso Ultrasonic Cleaner 29
14.2 Operating the device
Open the lid, and fill the stainless steel tank with water.
Place the item into the water. The item should be immerged
well into water. However, do not exceed the “MAX” mark.
Close the lid and plug in the appliance.
Press the ON button to start the cleaning process – the red
indication light turns on.
During cleaning, you can hear the ZIZI sound; it means the unit
is working.
The unit will stop automatically after 3 minutes. If another
cleaning is needed, press the ON button again.
You can press the OFF button during the cleaning if you want
to stop it.
When the cleaning is finished, unplug the unit and open the lid.
Take out the item. At last, pour the water from the stainless
steel tank and wipe it out.
► General Cleaning: Use only plain water for general cleaning. The water should merge
the item but not exceed the ruling mark.
► Enhanced Cleaning: When the item is smeary or extraordinary dirty, add about 5-10ml
of detergent (offered in specialised stores) or some drops of washing-up liquid into the
water to enhance the cleaning result.
► Extensive Cleaning. When the item needs extensive cleaning. “Enhanced Cleaning”
first, then replace the tank content with clean water and add about 5-10ml of detergent.
Start cleaning again for 3 minutes.
► Cleaning by Parts: For large items, place the item in the cleaner and use with open lid.
► Extensive Cleaning: When the item needs extensive cleaning. “Enhanced Cleaning”
first, then replace the tank content with clean water and add about 5-10ml of detergent.
Start cleaning again for 3 minutes.
Attention
► Running without water may damage the unit!
► Warning: Repeating cleaning cycles can enhance the cleaning effect. 3-minute cleaning
interval is recommended.