CellarPro SPLIT AIR HANDLER AH18SX, 15093 - Manual (Page 4)

4
CellarPro Optional Features
Electrode Canister Humidifier
Integrated inside the unit, the humidifier provides humidification to your cellar. An
optional electrode canister is available providing state-of-the-art humidity control.
The humidifier senses cylinder current draw, automatically flushing and filling the
cylinder to control the mineral content of the water and humidity output. The output
is field adjustable from 1 to 5 lbs/hr. A “Change Cylinder” light alerts service
personnel when the humidifier output requires service.
Electric Heat/Reheat
Electric reheat is designed to offset the cooling effect of the dehumidification
cycle; electric heat provides resistance heat regardless of the dehumidification
cycle. The unit incorporates a factory installed, wired and tested nichrome wire
heater. The heater has low voltage thermal safety cutouts with automatic reset
and a second power line fuse link (over-temperature) safety device for each bank
of heat.
Condensate Pump options
External: The condensate pump is factory mounted, wired and integrated into the
moisture removal system of the unit. In the event the condensate pump cannot
remove the water fast enough, an emergency shut-off switch locks out the
compressor and humidifier until the condensate pump has emptied its sump.
Internal: The condensate pump is factory mounted in the stainless steel
condensate pan, wired and integrated into the moisture removal system of the unit.
In the event the condensate pump cannot remove the water fast enough, an
emergency shut-off switch locks out the compressor and humidifier until the
condensate pump has emptied its sump.