BoonDocker YAMAHA WR-F: WR450F - Manual (Page 2)

Revised 3/19/2014 Page 2 of 5
www.boondockers.com………………..... ……….………………....877-522-7805
1.Remove seat, fuel tank, sub frame & air box.
Reinstall the sub frame. 2.Install control box. Install the Velcro on the
bar pad. Unplug the injector plug on the throttle
body, plug in the control box between the stock
harness & injector.
3.Unplug the map sensor for the WR & plug in
the BoonDocker map sensor connectors from the
control box. 4.Unplug the Throttle Position Sensor (TPS) &
plug in the Boondocker box to the TPS connec-
tors.
5.Unplug the coil input plug & plug in the Con-
trol box plug. NOTE; Route wires away from
heat & wear areas as much as possible. 6.Loosen the bolt on the left side of the frame &
install the ground wire to frame. This is on left
side of the bike right behind the top of the radia-
tor.