BoonDocker HONDA CRF: 450 Box Installation - Manual (Page 2)

Revised 4/22/2014 Page 2 of ?
www.boondockers.com………………..... ……….………………....877-522-7805
1. Route control box harness through handle
bars alongside with stock wire harness. Be sure
to zip tie to the stock wire harness. 2. Continue to route along the stock wire
harness. Keep using a zip tie to hold it in place.
3. Route under frame then over coolant hoses.
Zip tie harness where it wont touch hot parts or
rub and wear on moving parts. 4. Green wires go to the coil input on the
exhaust side of the engine.
5. Take the black wire along where the green
wire runs. Use the stock harness ground for the
control box ground. 6. Zip tie the green and black wires where they
will not rub or melt.