BoonDocker POLARIS RZR XP 900 Control Box Operation - Manual (Page 8)

Polaris RZR 900 Turbo Control Box Operation Instructions
Revised-04/25/2013 www.BoonDockers.com Page 8 of 8
Boost Screen
Position the → (cursor) next to # and press the SEL button to advance to the boost screen.
Boost screen: The boost screen has two adjustable values: Psi and Btn. The Psi value can be set to the
desired boost pressure. Once the desired boost pressure has been set, the Boondocker control box will
automatically adjust boost for changes in atmospheric pressure such as changes in elevation. Note: (The
minimum achievable boost pressure will be dependent on the waste gate actuator.)
Button (Btn): The value set below Btn is the amount of boost that can be momentarily added by pushing
the auxiliary button, when Btn is set to +HP in the Xtra menu (see page 6 for more details).
Boost Solenoid Installation
Install the boost solenoid in a pressure line between the air box (or charge tube) and wastegate actuator. Attach the metal port
of the solenoid with a 3/16” hose to the air box (or charge tube) fitting (see the figure below). Connect the right-angle port of
the solenoid with a 3/16” hose to the wastegate actuator. Attach a short length of hose to the third port and point it
downward so that it won’t get water in it. This is the actuator vent hose. Attach the solenoid so that it is supported. Use small
zip ties to secure the hoses to the ports.
MAIN FUEL Stats
MENU Xtra → # 5.0
Psi Btn
5.0← 2.0