BoonDocker POLARIS: Non-turbo Control Box 600/700/800 IQ Dragon - Manual (Page 9)

BoonDocker – 2379 Heyrend Way Idaho Falls, Idaho 83402 – 208-542-4411 / 877-522-7805
www.boondockers.com – email: [email protected] – fax: 208-524-7381
Revised 1-15-08 Page 9 of 14
VII. N2O System Configuration
A. N2O Configuration Options
There are seven ways to configure nitrous activation using one of more of the following inputs: button, throttle position
(requires installation of Boondocker TPS kit), and rpm range. A brief description for each configuration is given below.
More details can be found in sections B and C.
1. Button only: Pressing the momentary button activates the nitrous and releasing the button turns it off. The
button can be configured to activate the nitrous regardless of TPS or RPM conditions.
2. TPS (Throttle Position Sensor) only: When the throttle is pressed beyond a point set by the user, nitrous is
activated. Nitrous is deactivated when the throttle returns to a point below the chosen threshold.
3. TPS and RPM: When the RPM and TPS are within a range set by the user, nitrous will activate. Nitrous will
turn off when the throttle is decreased (TPS is below the adjustable threshold) or when the RPM is out of the
selected range (lower than Min or higher than Max).
4. Button (N2O) or TPS: The handlebar button can be used in combination with the TPS. In this way, either the
throttle or the button can activate the nitrous. The button will always activate nitrous regardless of the TPS
condition.
5. Button (N2O) or TPS and RPM: The handlebar button can be used in combination with the TPS and RPM
range. In this way, either the throttle/RPM or the button can activate the nitrous. The button will always activate
nitrous regardless of the TPS and RPM conditions.
6. Button (ARM) and TPS: The nitrous button input on the Control Box can be used to quickly arm and disarm
nitrous capability. When armed (button input is on), the system can be configured to activate with TPS.
Optionally, the handlebar button, which is momentary (only activated while pressed), can be replaced with a
toggle, rocker, or slide switch so it remains in the on or off position (when not pressed).
7. Button (ARM) and TPS and RPM: Same as option 6 above except with RPM capability. When armed (button
input is on), the system can be configured to activate with TPS and RPM.
B. N2O Configuration Procedure
Note: All nitrous configuration settings are stored in the same map as the EFI settings. All changes you make become
part of the current map. The current map number is shown in the Main Menu.
From the Main Menu, select the N2O option. Below is a description of this menu:
Fuel TPS RPM Btn

050 OFF OFF OFF
Fuel 050
Fuel setting during nitrous activation
TPS OFF
Shows TPS mode is OFF or displays TPS trigger value
RPM OFF
Shows whether RPM mode is ON or OFF
Btn OFF
Displays button mode (described in detail below)
Fuel: The nitrous fuel adjustment tuning procedure is described above in section VIII.
If box in in N2O:ADJ (adjustable regulator) mode:
Use the 180 and 340 settings to customize the N2O Fuel Adjustment Line for your engine and nitrous nozzle
sizes.
340 180psi FDly

050 025 000
The 340 and 180 fuel settings are used to create a Fuel
Adjustment Line (see graph) which allows nitrous fuel to be
automatically adjusted according to N2O pressure...