BoonDocker YAMAHA: Non-turbo Control Box Phazer User Manual
Page 15
BoonDocker – 2379 Heyrend Way Idaho Falls, Idaho 83402 – 208-542-4411 / 877-522-7805
www.boondockers.com – email:
– fax: 208-524-7381
Revised 02-14-07
Page 15 of 17
4. Button (N2O) or TPS: Activate
nitrous when button is pressed or
when Throttle is pressed beyond a
set level.
Fuel TPS RPM Btn
040 200 OFF
N2O
Set: TPS to ON (set TPS threshold to desired
level), RPM to OFF, and Btn to N2O.
5. Button (N2O) or TPS and
RPM: Activate nitrous when
button is pressed or when Throttle
is pressed beyond a set level AND
the RPM's are within a certain
range.
Fuel TPS RPM Btn
040 200 ON
N2O
Set: TPS to ON (set TPS threshold to desired
level), RPM to ON (set Min/Max values),
and Btn to N2O.
6. Button (ARM) and TPS:
Activate nitrous when button
input is on (armed) AND Throttle
is pressed beyond a set level.
Fuel TPS RPM Btn
040 200 OFF
ARM
Set: TPS to ON (set TPS threshold to desired
level), RPM to OFF, and Btn to ARM.
7. Button (ARM) and TPS and
RPM: Activate nitrous when
button input is on (armed) AND
Throttle is pressed beyond a set
level AND the RPM’s are within
a certain range.
Fuel TPS RPM Btn
040 200 ON
ARM
Set: TPS to ON (set TPS threshold to desired
level), RPM to ON (set Min/Max values),
and Btn to ARM.
N2O Pressure Transducer Faults
When the nitrous button is pressed, the Control Box first checks to make sure the readings from the pressure
transducer are correct. One of the following two fault messages may be displayed. If a fault message is displayed,
the nitrous solenoid will not operate and the message will remain displayed until any key is pressed to clear it or the
engine is restarted.
ERROR: N2O press
too LOW! .
This screen may appear if the pressure in the N2O tank is zero, the transducer is unplugged, or there is a wiring
problem.
Important Note: If the bottle becomes empty, this message will be displayed and nitrous will be shut off to prevent
extra fuel from being added without nitrous!
ERROR: N2O press
over 2000psi .
This screen will appear if the pressure transducer senses a pressure above 1000psi for regulated systems or 2000psi
for non-regulated systems.