Code 3 2005 + Impala Passenger Side - Manual (Page 3)

3
Installation Instructions - Cont:
Step 6. Drop the speaker assembly into the headlight cavity (See Figure -10) then rotate the speaker bracket mounting
flange forward & down into the headlight cavity while lowering the speaker deeper into the space below the headlight
(See Figure -11). NOTE: The vehicle's flexible plastic front shroud and it's parts below will flex out of the way to
allow the speaker assembly to drop into position. Space is tight but it will fit!
Step 7. Once the bracket is in position, thread the bumper bolts back into their holes (see Figure -12). Lift up on the
speaker and thread the supplied 1/4" X 5/8" Long Slot/Hex head sheet metal screw through the slot in the Speaker
Mounting Bracket and into the hole in the side of the vehicle's frame (See Arrow in Figure -13).
Step 8. Tighten up the bumper bolts and remove the 1/4" X 5/8" Long Slot/Hex head screw for the next step.
Step 9. Again take note and keep track of which horn is the bottom and which is the top, remove the hex nuts fastening
the horns to the vehicle's OEM horn mounting bracket (See Figures 14 & 15). Discard the OEM horn bracket. Mount
the horns to the supplied Horn Relocation/Mounting Bracket as shown in Figure -16 (Attach the TOP HORN first) &
Figure -17 (BOTTOM HORN). Only tighten the horn fastening nuts finger tight at this time so they can be adjusted later.
FIGURE -9 FIGURE -10 FIGURE -11
FIGURE -12 FIGURE -13 FIGURE -14 - BOTTOM HORN
FIGURE 15 - TOP HORN FIGURE -16 - TOP HORN FIGURE -17 - BOTTOM HORN