Code 3 2100 - Manual (Page 8)

8
LED DIRECTIONAL MODULES
In addition to the 360 warning modules the lightbar may be equipped with a number of single head directional warning LED
modules. These modules are available in either the LED X™ ( 1" X 4" ) ,6-LED OPTIX™ ( 1" X 6" ), 3-LED OPTIX (1"x4"), 33
OPTIX (two 3-Up heads using one 6-LED OPTIX optic) or LC-LED directional modules in stationary and flashing versions ( see
figure 6). The stationary versions can be flashed by connecting the module(s) to any flasher that does not require ground
through the load (example: Code 3® 700 series relay flasher). The flashing modules will have "Cycleflash" as the standard
pattern. The OPTIX and LEDX flash pattern can be changed by shorting the 2-pin header, J1 as shown in Figure 7,
momentarily then releasing. Table 2 shows the available patterns and the order when stepping through patterns. The module
can be reset to "Cycleflash" by shorting the header for greater than 5 seconds and releasing. The LC-LED Modules flash
patterns can be changed as described on page 9.
Operating Specifications for directional module:
Operating Voltage: 10-16 VDC, Reverse Polarity Protection
Current Draw : Flashing Module
Red/Amber - .25A avg @ 12.8 Volts
Blue/White - .4A avg @ 12.8 Volts
Steady Burn Module
Red/Amber - .5A avg @ 12.8 Volts
Blue/White - .8A avg @ 12.8 Volts
Available Colors - Red , Blue, Amber, and White
BLACK
RED
T01215
T00243
FIGURE 6
BLACK
RED
T01215
T00243
LED X™ ( 1" X 4" ) LC-LED (1"x4")
MODULES
OPTIX ( 1" X 6" )
MODULES
DIMMING
WIRES
DIMMING
WIRES