Code 3 21IF - Manual (Page 8)

8
Maintenance
Lens Cleaning
Use plain water and a soft cloth, or Code 3® lens polish and a very
soft paper towel or facial tissue. Because plastic scratches easily,
cleaning is recommended only when necessary (about every
six months). Do not subject the lenses to car washes that use
brushes, as these will scratch the lenses.
Lens removal
First, disengage the lens clips (4 per lens) as shown in Figure 6.
Finally, insert a screwdriver into the small slot in the lens clip pocket or
the lens edge, and twist the screwdriver to lift the lens.
FIgUrE 6
Twist to
Lift Lens
Pry
Up to
remove
Lens
Clip
Light Head Modules
Light Head removal and/or Lamp replacement
Directional/Corner: Remove single screw securing the light head assembly to the flat plate, lift light head assembly, and
then remove the control wire. reference Figure 7.
LED TD/Alley: Remove the single screw securing the light head assembly to the flat plate, lift light head assembly, and
then disconnect the red wire from the control wire by decoupling the quick slides (make sure to pull on the quickslides
only, not the wires). reference Figure 7.
MR11 Halogen TD/Alley: Remove the two screws securing the light head assembly to the flat plate, lift light head as-
sembly, and then disconnect the red wire from the control wire by decoupling the quick slides (make sure to pull on the
quickslides only, not the wires). remove the lamp assembly by removing the appropriate fasteners, remove fasteners
sandwiching Mr11 in bracket, and remove lamp. replace the lamp and reassemble. reference Figure 7.
Mr11 Halogen
FIgUrE 7
Directional
Module
Corner
Module
LED TD/Alley
Module