Code 3 900-06 Flashers - Manual (Page 3)

Installation:
Remove the radiator
shroud by removeing the
plastic retaining screws.
Using a clean shop towel
wipe off any dust or dirt
that may be on the
radiator core support in
the designated mounting
location (see Fig 1).
Remove the backing from
the mounting tape on the
flasher and press the
flasher firmly into place.
Two additional holes are
provided in the flasher's
mounting flange for user
supplied mounting
screws if desired.
3
Locate the Ford headlight flasher connector in front of the radiator and
remove the jumper plug. Carefully route the flasher's two wire cable with
the mating connector to the front of the radiator and plug it into the ford
connector.
Route the remaining wires as necessary to ensure that they will not be
damaged during operation of the vehicle and that they do not interfere with
the operation of the vehicel. Connect the wires as follows:
Black - Connect to battery negative (vehicle ground)
Red - Connect to +12V battery power
Brown - Connect to the vehicles low beam headlight wiring if
Night Cancel of the headlight flasher function is desired. Other-
wise, cut off the exposed end of the wire and tape with electrical
The orange wire and the white wire are used to enable the desired head-
light flash function. Route these wires to the output of your light control.
The table below shows the function of each wire.
Flasher Mode Orange WIre White Wire
OFF 0 0
160 fpm 0 +10-16 Volts
114 fpm +10-16 Volts 0
Variable 114-180 fpm +10-16 Volts +10-16 Volts