Installation and operation, Model 950, Installation – Code 3 950 and 960 Flashers User Manual

Page 4

Advertising
background image

4

FIGURE 1: WIRING DIAGRAM FOR 950

HEADLIGHT FLASHER INSTALLATION

Installation and Operation

Installation

Follow the steps below to properly install your 900 Series Headlight Flasher. Refer to Figure 1 while
installing the Model 950 Headlight Flasher. Refer to Figure 2 while installing the 960 Headlight Flasher.
Refer to the vehicle manufacturer's maintenance manual for detailed information on the headlight wiring.

NOTE: Use #14 AWG wire minimum for the headlight and power/ground connections and 18 AWG wire
minimum for the Orange, White and Brown control wire connections.

1)

Mount the Flasher Unit in a convenient location away from direct heat sources or water
splashes. A common location is in the grill area near the passenger's side headlight assembly.
Use either mounting method mentioned under “Mounting Methods,” above.

2)

Connect a user supplied fuse holder in-line between the positive (+) post of the battery and Red
wire of the Flasher Unit.

CAUTION: Leave the fuse out of the fuse holder until ready to test the completed installation.

3)

Install a user supplied switch in a convenient location on the instrument panel near the driver.

4)

Near the Passenger's side headlight assembly, locate and cut the wire going to the Driver's
side highbeam headlight circuit.

5)

Connect the Passenger's side highbeam headlight wire to the Blue wire of the Flasher Unit.
The Passenger's side highbeam headlight wire should still be connected to the vehicle's
highbeam control wire.

6)

Connect the Driver's side headlight high beam wire to the Yellow wire of the Flasher Unit.

7)

(OPTIONAL) Connect the vehicle’s low beam headlight circuit to the Brown wire of the Flasher
Unit.

NOTE: For continued high beam flash when the low beam lights are on, do not connect the Brown wire.

8)

Connect the negative (-) post of the battery, or other good ground(earth), to the Black wire of
the Flasher Unit.

Double check all of your connections then refer to the section on testing the circuit.

UPÃW@CD8G@TÃGPXÃ7@6HÃXDS@ÃAPSÃIDBCUÃ9DT67G@ÃPIG`

W@CD8G@TÃCDBCÃ7@6HÃXDS@

SDBCUÃCDBCÃ7@6H

G@AUÃCDBCÃ7@6H

AG6TCÃ@I67G@Ã

AG6TCÃ@I67G@Г!

#Г6XBÃHDI

!PÃ6HQÃAVT@

7SPXI

`@GGPX

7GV@

XCDU@
PS6IB@

7G68F
S@9

8VUÃC@S@

%$77(5<

'Ã6XBÃHDI

Model

950

Advertising