Code 3 for 2011 Ford PI Utility and Explorer - Manual

1
INSTALLATION &
OPERATION
MANUAL
Read all instructions and warnings before installing and using.
This manual must be delivered to the end user of this equipment.
IMPORTANT:
INSTALLER:
2011 FORD PI UTILITY & EXPLORER
PAR 36 LED LIGHT HEAD
Table of Contents:
Page No: Description:
1. Preparation for installation
2. Installation on vehicle supplied with fog lights from factory
3. Reinstalling the vehicle facia, Wiring connections
4. Warranty Information
Code 3 Par 36 LED light heads are sold separately:
Please call Code 3 customer service for LED configura-
tions and pricing available.
Preparation for Installation:
1. Access to the rear of the front facia is required in order to complete hardware installation and make
wiring connections.
• Remove top engine shroud cover (2 push in fasteners & 6 hex head screws)
• Remove phillips head screws from both front wheel well forward areas
• Remove hex head screws from lower facia behind air dam area of vehicle
• Remove (2) phillips head screws from DS & PS facia under front wheel well trim
• Remove facia & grill from vehicle & unplug fog light connectors DS & PS
2011 FORD PI UTILITY & EXPLORER
PAR 36 LED LIGHT HEAD